Command Manual - Security
Quidway S2000 Series Ethernet Switches Chapter 2 AAA Configuration Commands
2-30
Parameter
huawei: Configures the switch system to support the RADIUS server of Huawei type,
which requires the RADIUS client end (switch system) and RADIUS server to interact
according to the private RADIUS protocol regulation and packet format of Huawei
Technologies Co., Ltd.
iphotel: Configures the switch system to support the RADIUS server of IP Hotel type,
which requires the RADIUS client end (switch system) and RADIUS server to interact
according to the regulation and packet format of IP Hotel (an extension of RADIUS
protocol).
portal: Configures the switch system to support the RADIUS server of portal type,
which requires the RADIUS client end (switch system) and RADIUS server to interact
according to the regulation and packet format of Portal (an extension of RADIUS
protocol).
standard: Configures the switch system to support the RADIUS server of Standard
type, which requires the RADIUS client end (switch system) and RADIUS server to
interact according to the regulation and packet format of standard RADIUS protocol
(RFC 2138/2139 or newer).
Description
Using server-type command, you can configure the RADIUS server type supported by
the switch. Using undo server-type command, you can restore the RADIUS server
type to the default setting
By default, the value is standard.
Huawei Quidway Series Ethernet Switches support standard RADIUS protocol and the
extended RADIUS service platform IP Hotel, 201+ and Portal etc independently
developed by Huawei Technologies. This command is used to select the supported
RADIUS sever type.
For the related command, see radius scheme.
Example
# Set RADIUS server type of RADIUS sever group, “huawei” to IP Hotel.
[Quidway-radius-huawei] server-type iphotel
2.2.18 state
Syntax
state { primary | secondary } { accounting | authentication } { block | active }
View
RADIUS server group view
To Next Page
Loading...
Need help?
General