Command Manual - Getting Started
Quidway S2000 Series Ethernet Switches Chapter 1 Logging in Ethernet Switch Commands
1-2
1.1.2 auto-execute command
Syntax
auto-execute command text
undo auto-execute command
View
User interface view
Parameter
text: Specifies the command to be run automatically.
Description
Using auto-execute command command, you can configure to automatically run a
specified command. When a user logs in, the command configured will be executed
automatically. The user will be disconnected after that. Using undo auto-execute
command command, you can configure not to run the command automatically.
This command is usually used to configure the telnet command on the terminal, which
will connect the user to a designated device automatically.
By default, auto run is disabled.
Caution:
1) If you execute this command, the user-interface can no longer be used to perform routine
configurations on the local system. Therefore use caution when using this command.
2) Ensure that you will be able to log into the system in some other way to cancel the configuration,
before you configure the auto-execute command command and save the configuration.
Example
# Configure to automatically telnet 10.110.100.1 after the user logs in via VTY 0.
[Quidway-ui-vty0] auto-execute command telnet 10.110.100.1
1.1.3 command-privilege level
Syntax
command-privilege level
level
view
view command
undo command-privilege view
view command
To Next Page
Loading...
Need help?
General