Huawei Quidway S2000 Series User Manual

Command Manual - QoS/ACL
Quidway S2000 Series Ethernet Switches Chapter 1 ACL Commands
1-3
Basic ACL 2010, 1 rule,
rule 1 permit 10.0.0.1 0 (0 times matched)
Basic ACL 2020, 1 rule,
rule 2 permit 20.0.0.1 0 (0 times matched)
Basic ACL std1, 2 rules,
rule 1 permit 20.0.0.1 0 (0 times matched)
rule 2 permit 30.0.0.1 0 (0 times matched)
Table 1-1 the display Information
Field Description
Basic ACL 2010, 1 rule,
rule 1 permit
10.0.0.1 0 (0 times
matched)
“Basic ACL” delegates the type of ACL, the type of ACL can be “advanced ACL”, “Basic
ACL”, “Interface based ACL” or “Link ACL”. “2020” indicates the number of ACL ( in this
location, it may be the name of the ACL) , “1 rule” indicates the rule number of the ACL.
“ rule 1 permit 10.0.0.1 0 (0 times matched)” indicates the rule’s content
1.1.3 display time-range
Syntax
display time-range { all | name }
View
Any view
Parameter
all: Configures to display all the time range.
name: Specifies the name of the time range.
Description
Using display time-range command, you can view the configuration and status of the
current time range. You will see the active or inactive state outputs respectively.
Note that the system has a delay of about 1 minute when updating the ACL state,
while the display time-range command applies the current time. Therefore when
display time-range displays that a time range is active, the ACL using it may not have
been activated. This is a kind of normal case.
Example
# Display the configuration of all the time ranges.
<Quidway> display time-range all

Huawei Quidway S2000 Series Specifications

General

Brand	Huawei
Model	Quidway S2000 Series
Category	Switch
Language	English