Huawei Quidway S2000 Series User Manual

Command Manual - Getting Started
Quidway S2000 Series Ethernet Switches Chapter 1 Logging in Ethernet Switch Commands
1-12
This command can only be performed in AUX user interface view.
By default, the mode is set to none.
Example
# Set mark parity on the AUX (Console) port.
[Quidway-ui-aux0] parity mark
1.1.16 quit
Syntax
quit
View
Any view
Parameter
none
Description
Using quit command, you can return to the lower level view from the current view. If
the current view is user view, you can quit the system.
There are three levels of views, which are listed from low to high as follows:
z
User view
z
System view
z
VLAN view, Ethernet port view, and so on.
For the related commands, see return, system-view.
Example
# Return to user view from system view.
[Quidway] quit
<Quidway>
1.1.17 return
Syntax
return
View
System view

Huawei Quidway S2000 Series Specifications

General

Brand	Huawei
Model	Quidway S2000 Series
Category	Switch
Language	English