Command Manual - Security
Quidway S2000 Series Ethernet Switches Chapter 2 AAA Configuration Commands
2-6
State = Active AccessLimit = Disable
Domain User Template:
Idle cut = Disable
Default Domain Name: system
Total 1 domain(s).1 listed.
2.1.6 display local-user
Syntax
display local-user [ domain isp-name | idle-cut { enable | disable } | service-type
{ telnet | ftp | lan-access } | state { active | block } | user-name user-name | vlan
vlanid ]
View
Any view
Parameter
domain isp-name: Configures to display all the local users in the specified ISP domain.
isp-name specifies the ISP domain name with a character string not exceeding 24
characters. The specified ISP domain shall have been created.
idle-cut: Configures to display the local users according to the state of idle-cut function.
disable means that the user disables the idle-cut function and enable means the user
enables the function.
service-type: Configures to display local user of a specified type. telnet means that:
the specified user type is telnet. ftp means that: the specified user type is ftp.
lan-access means that the specified user type is lan-access which mainly refers to
Ethernet accessing users, 802.1x supplicants for example.
state { active | block } Configures to display the local users in the specified state.
active means that the system allows the user requesting network service and block
means the system does not allow the user requesting network service.
user-name user-name : Configures to display a user specified with user-name .
user-name is the argument specifying the username. It is a character string not
exceeding 32 characters, excluding “/”, “:”, “*”, “?”, “<” and “>”. The @ character can
only be used once in one username. The pure username (the part before @, namely
the user ID) cannot exceed 24 characters.
vlan vlanid: Configures to display the users belonged to specified VLAN. vlanid is the
integer, ranging from 1 to 4094.
To Next Page
Loading...
Need help?
General