Huawei Quidway S2000 Series User Manual

Command Manual - Security
Quidway S2000 Series Ethernet Switches Chapter 2 AAA Configuration Commands
2-32
Parameter
none
Description
Using stop-accounting-buffer enable command, you can configure to save the
stopping accounting requests without response in the switch system buffer. Using
undo stop-accounting-buffer enable command, you can cancel the function of
saving the stopping accounting requests without response in the switch system buffer.
By default, enable to save the stopping accounting requests in the buffer.
Because the stopping accounting request concerns account balance and will affect the
amount of charge, which is very important for both the user and ISP, NAS shall make its
best effort to send the message to RADIUS accounting server. Accordingly, if the
message from the switch to RADIUS accounting server has not been responded, the
switch shall save it in the local buffer and retransmit it until the server responds or
discard the messages after transmitting for specified times.
For the related commands, see reset stop-accounting-buffer, radius scheme,
display stop-accounting-buffer.
Example
# Indicate that, for the server “Huawei” in the RADIUS server group, the switch system
will save the stopping accounting request packets in the buffer
[Quidway-radius-huawei] stop-accounting-buffer enable
2.2.20 timer
Syntax
timer seconds
undo timer
View
RADIUS server group view
Parameter
seconds
: RADIUS server response timeout timer, ranging from 1 to 10 and measured
in seconds. By default, the value is 3.
Description
Using timer command, you can configure RADIUS server response timer. Using undo
timer command, you can restore the default value of the timer.

Huawei Quidway S2000 Series Specifications

General

Brand	Huawei
Model	Quidway S2000 Series
Category	Switch
Language	English