To Next Page

To Previous Page

Command Manual - System Management

Quidway S2000 Series Ethernet Switches Chapter 4 System Maintenance Commands

4-27

channel-name: Specify the channel name. The name can be channel6, channel7,

channel8, channel9, console, logbuffer, loghost, monitor, snmpagent,

trapbuffer.

facility: Configure the recording tool of info-center loghost.

local-number: Record tool of info-center loghost, ranging from local0 to local7.

language: Set the logging language.

chinese,english: Language used in log file.

Description

Using info-center loghost command, you can configure the IP address of the

info-center loghost to send information to it. Using undo info-center loghost

command, you can cancel output to info-center loghost.

By default, Ethernet switches do not output information to info-center loghost.

This command takes effect only after the system logging is enabled.

For the related commands, see info-center enable,display info-center.

Example

# Configure to send log information to the UNIX workstation at 202.38.160.1.

[Quidway] info-center loghost 202.38.160.1

4.5.8 info-center loghost source

Syntax

info-center loghost source interface-name

undo info-center loghost source

View

System view

Parameter

source interface-name: set source address of the packets sent to loghost as the

address of the interface specified by the interface-name. Normally, the interface should

be VLAN interface.

Huawei Quidway S2000 Series User Manual

Questions and Answers: