Huawei Quidway S2000 Series User Manual

Command Manual - Getting Started
Quidway S2000 Series Ethernet Switches Chapter 2 System IP Configuration Commands
2-10
Example
# Display the verbose routing table information.
<Quidway> display ip routing-table verbose
Routing Tables:
Generate Default: no
+ = Active Route, - = Last Active, # = Both * = Next hop in use
Destinations: 3 Routes: 3
Holddown: 0 Delete: 62 Hidden: 0
**Destination: 1.1.1.0 Mask: 255.255.255.0
Protocol: #DIRECT Preference: 0
*NextHop: 1.1.1.1 Interface: 1.1.1.1(Vlan-interface1)
State: <Int ActiveU Retain Unicast>
Age: 20:17:41 Cost: 0/0
**Destination: 1.1.1.1 Mask: 255.255.255.255
Protocol: #DIRECT Preference: 0
*NextHop: 127.0.0.1 Interface: 127.0.0.1(InLoopBack0)
State: <NoAdvise Int ActiveU Retain Gateway Unicast>
Age: 20:17:42 Cost: 0/0
**Destination: 2.2.2.0 Mask: 255.255.255.0
Protocol: #DIRECT Preference: 0
*NextHop: 2.2.2.1 Interface: 2.2.2.1(Vlan-interface2)
State: <Int ActiveU Retain Unicast>
Age: 20:08:05 Cost: 0/0
First, display statistics of the whole routing table and then output detailed information
of every route entry in turn. The meaning of route status is shown in Table 2-5, and the
statistics of routing table is shown in the following table.
Table 2-6 Description of information generated by the command display ip routing-table verbose
Field Description
Holddown Number of held-down routes
Delete Number of deleted routes
Hidden Number of hidden routes
2.1.9 interface vlan-interface
Syntax
interface vlan-interface vlan-id
undo interface vlan-interface
vlan-id

Huawei Quidway S2000 Series Specifications

General

Brand	Huawei
Model	Quidway S2000 Series
Category	Switch
Language	English