Huawei Quidway S2000 Series

Command Manual - Getting Started
Quidway S2000 Series Ethernet Switches Chapter 1 Logging in Ethernet Switch Commands
1-22
<Quidway1> telnet 129.102.0.1
Trying 129.102.0.1
Connected to 129.102.0.1
<Quidway2>
1.1.30 user-interface
Syntax
user-interface [ type ] first-number [ last-number ]
View
System view
Parameter
type: Specifies the user interface type, which can be aux or vty.
first-number: Specifies the number of the first user interface to be configured.
last-number: Specifies the number of the last user interface to be configured.
Description
Using user-interface command, you can enter single user interface view or multiple
user interface views to configure the corresponding user interfaces.
Example
# Enter user interface view 0 through 5, that is, 1 AUX (Console) port user interface
view and 5 VTY user interface views.
[Quidway] user-interface 0 5
[Quidway-ui0-5]
1.1.31 user privilege level
Syntax
user privilege level level
undo user privilege level
View
User interface view
Parameter
level: Specifies which level of command a user can use after logon from the
specifically user interface, ranging from 0 to 3.