Huawei Quidway S2000 Series User Manual

Command Manual - Getting Started
Quidway S2000 Series Ethernet Switches Chapter 1 Logging in Ethernet Switch Commands
1-7
1.1.8 flow-control
Syntax
flow-control { hardware | none | software }
undo flow-control
View
User interface view
Parameter
hardware: Configures to perform hardware flow control.
none: Configures no flow control.
software: Configures to perform software flow control.
Description
Using flow-control command, you can configure the flow control mode on AUX
(Console) port. Using undo flow-control command, you can restore the default flow
control mode.
This command can only be performed in AUX user interface view.
By default, the value is none. That is, no flow control will be performed.
Example
# Configure software flow control on AUX (Console) port.
[Quidway-ui-aux0] flow-control software
1.1.9 free user-interface
Syntax
free user-interface [ type ] number
View
User view
Parameter
type
: Specifies the user interface type.
number
: Specifies the absolute/relative number of the user interface. Configured
together with the
type
, it will specify the user interface number of the corresponding
type. If the type is not specified, number will specify an absolute user interface
number.

Huawei Quidway S2000 Series Specifications

General

Brand	Huawei
Model	Quidway S2000 Series
Category	Switch
Language	English