Huawei Quidway S2000 Series

Command Manual - Port
Quidway S2000 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
1-7
Parameter
auto: Port auto-negotiation attribute.
full: Port full-duplex attribute.
half: Port half-duplex attribute.
Description
Using duplex command, you can configure the full-duplex/half-duplex attribute of the
Ethernet port. Using undo duplex command, you can restore the duplex attribute of
the port to default auto-negotiation mode.
By default, the duplex attribute is auto.
For the related command, see speed.
Example
# Configure the Ethernet port Ethernet0/1 as auto-negotiation attribute.
[Quidway-Ethernet0/1] duplex auto
1.1.8 flow-control
Syntax
flow-control
undo flow-control
View
Ethernet port view
Parameter
none
Description
Using flow-control command, you can enable flow control feature on the Ethernet
port to avoid discarding data packets due to congestion. Using undo flow-control
command, you can disable flow control feature.
By default, flow control on the Ethernet port is disabled.
Example
# Enable flow control on Ethernet0/1.
[Quidway-Ethernet0/1] flow-control