To Next Page

To Previous Page

Command Manual - Network Protocol

Quidway S2000 Series Ethernet Switches Chapter 1 ARP Configuration Commands

1-2

Static ARP map entry will be always valid as long as Ethernet switch works

normally. But if the VLAN corresponding ARP mapping entry is deleted, the ARP

mapping entry will be also deleted. The valid period of dynamic ARP map entries

will last only 20 minutes by default.

The parameter vlan-id must be the ID of a VLAN that has been created by the user,

and the Ethernet port specified behind this parameter must belong to the VLAN.

For the related command, see reset arp, display arp, debugging arp.

Example

# Associate the IP address 202.38.10.2 with the MAC address 00e0-fc01-0000, and

the ARP mapping entry belongs to the Ethernet port Ethernet0/1 on VLAN1.

[Quidway] arp static 202.38.0.10 00e0-fc01-0000 1 ethernet0/1

1.1.2 arp timer aging

Syntax

arp timer aging aging-time

undo arp timer aging

View

System view

Parameter

aging-time

: Aging time of dynamic ARP aging timer, which is in the range of 1 to 1440

minutes. By default, the aging time is 20 minutes.

Description

Using arp timer aging command, you can configure the dynamic ARP aging timer.

Using undo arp timer aging command, you can restore the default dynamic ARP

aging time.

For the related command, see display arp timer aging.

Example

# Configure the dynamic ARP aging timer to 10 minutes.

[Quidway] arp timer aging 10

Huawei Quidway S2000 Series User Manual

Questions and Answers: