Command Manual - Integrated Management
Quidway S2000 Series Ethernet Switches Chapter 1 HGMP V2 Configuration Commands
1-4
Table 1-1 Information about NDP configuration the NDP neighbors discovered by a port
Field Description
Neighbor Discovery Protocol is enabled The system NDP is enabled on the switch
Neighbor Discovery Protocol Ver: 1 The NDP version
Hello Timer: 60(s)
The current device transmits NDP packet every 60
seconds.
Aging Timer: 180(s)
A neighbor keeps the NDP information of the current
device for 180 seconds.
Interface: Ethernet0/1 Port number, specify a port
Status: Enabled NDP is enabled on the port
Pkts Snd: 89 Number of NDP packets transmitted from a port
Pkts Rvd: 262 Number of NDP packets received by a port
Pkts Err: 0 Number of error NDP packets received by a port
Neighbor 1: Aging Time: 170(s)
The neighbor NDP information aging time connected by
the port
MAC Address MAC address of a neighbor device
Port Name Port name of a neighbor device
Software Ver The software version of a neighbor device
Device Name Device name of a neighbor device
Port Duplex Port duplex mode of a neighbor device
Product Ver The product version of a neighbor device
1.1.2 ndp enable
Syntax
ndp enable [ interface port-list ]
undo ndp enable [ interface port-list ]
View
System view or Ethernet port view
Parameter
interface port-list: Specifies a list of ports isolated from the specified port. A list may
contain consecutive or separated ports, or the combination of consecutive and
separated ports. The parameter is expressed as { interface_type interface_num |
interface_name } [ to { interface_type interface_num | interface_name } ] } &<1-10>.
interface_type specifies the port type. interface_num specifies the port number,
expressed as slot number/port number. Key word to helps specify a port range.
Description
Using ndp enable command, you can enable NDP on a system in system view, or
enable it on a port in Ethernet port view. Using undo ndp enable command, you can
disable NDP on a system in system view, or disable it on a port in Ethernet port view.