Command Manual - System Management
Quidway S2000 Series Ethernet Switches Chapter 1 File System Management Commands
1-21
Description
Using ascii command, you can configure data transmission mode as ASCII mode.
By default, the file transmission mode is ASCII mode.
Perform this command if the user needs to change the file transmission mode to default
mode.
Example
# Configure to transmit data in the ASCII mode.
[ftp] ascii
200 Type set to A.
1.4.2 binary
Syntax
binary
View
FTP Client view
Parameter
none
Description
Using binary command, you can configure file transmission type as binary mode.
Example
# Configure to transmit data in the binary mode.
[ftp] binary
200 Type set to I.
1.4.3 bye
Syntax
bye