Command Manual - System Management
Quidway S2000 Series Ethernet Switches Chapter 7 NTP Configuration Commands
7-6
View
System view
Parameter
None
Description
Using ntp-service authentication enable command, you can enable the NTP-service
authentication function. Using undo ntp-service authentication enable command,
you can disable this function.
By default, the authentication is disabled.
Example
# Enable NTP authentication function.
[Quidway] ntp-service authentication enable
7.1.7 ntp-service authentication-keyid
Syntax
ntp-service authentication-keyid
number
authentication-mode md5
value
undo ntp-service authentication-keyid number
View
System view
Parameter
number
: Specify the key number and range from 1 to 4294967295.
value
: Specify the value of the key with 1 to 32 ASCII characters.
Description
Using ntp-service authentication-keyid command, you can set NTP authentication
key. Using undo ntp-service authentication-keyid command, you can cancel the
NTP authentication key.
By default, there is no authentication key.