Huawei Quidway S2000 Series User Manual

Command Manual - Port
Quidway S2000 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
1-12
1.1.15 loopback-detection per-vlan enable
Syntax
loopback-detection per-vlan enable
undo loopback-detection per-vlan enable
View
Ethernet port view
Parameter
none
Description
Using the loopback-detection per-vlan enable command, you can configure that the
system performs loopback detection to all VLANs on Trunk and Hybrid ports. Using
the undo loopback-detection per-vlan enable command, you can configure that the
system only performs loopback detection to the default VLANs on the port.
By default, the system performs loopback detection to all VLANs on Trunk and Hybrid
ports.
Example
# Configure the detection interval for the external loopback condition of each port to 10
seconds.
[Quidway-Ethernet0/1] loopback-detection per-vlan enable
1.1.16 mdi
Syntax
mdi { across | auto | normal }
undo mdi
View
Ethernet port view
Parameter
across: The network cable type is cross-over cable.
auto: The network cable will be recognized whether it is straight-through cable or
cross-over cable.
normal: The network cable of the port is straight-through cable.

Huawei Quidway S2000 Series Specifications

General

Brand	Huawei
Model	Quidway S2000 Series
Category	Switch
Language	English