Huawei Quidway S2000 Series User Manual

Command Manual - System Management
Quidway S2000 Series Ethernet Switches Chapter 5 SNMP Configuration Commands
5-18
Parameter
length: Length of queue, ranging from 1 to 1000; By default, the length is 100.
Description
Using snmp-agent trap queue-size command, you can configure the information
queue length of Trap packet sent to destination host. Using undo snmp-agent trap
queue-size command, you can restore the default value.
For the related commands, see snmp-agent trap enable, snmp-agent target-host,
snmp-agent trap life.
Example
# Configure the queue length to 200.
[Quidway] snmp-agent trap queue-size 200
5.1.20 snmp-agent trap source
Syntax
snmp-agent trap source vlan-interface vlan-id
undo snmp-agent trap source
View
System view
Parameter
vlan-id: Specify the VLAN interface ID, ranging from 1 to 4000.
Description
Using snmp-agent trap source command, you can configure the source address for
sending Trap. Using undo snmp-agent trap source command, you can cancel the
source address for sending Trap.
Example
# Configure the IP address of the VLAN interface 1 as the source address for
transmitting the Trap packets.
[Quidway] snmp-agent trap source vlan-interface 1

Huawei Quidway S2000 Series Specifications

General

Brand	Huawei
Model	Quidway S2000 Series
Category	Switch
Language	English