Huawei Quidway S2000 Series User Manual

Command Manual - Port
Quidway S2000 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
1-1
Chapter 1 Ethernet Port Configuration Commands
1.1 Ethernet Port Configuration Commands
1.1.1 broadcast-suppression
Syntax
broadcast-suppression pct
undo broadcast-suppression
View
Ethernet port view
Parameter
pct: Specifies the maximum wire speed ratio of the broadcast traffic allowed on the
port. The value ranges from 5 to 100. The step is 5. By default, the value is 100. The
smaller the ratio is, the smaller the broadcast traffic is allowed.
Description
Using broadcast-suppression command, you can configure the broadcast traffic size
enabled on port. Once the broadcast traffic exceeds the value set by the user, the
system will discard some broadcast to ensure network service so that the traffic ratio
of broadcast is maintained in a proper range. Using undo broadcast-suppression
command, you can restore the default broadcast traffic enabled on port as 100. i.e.,
100% broadcast traffic is allowed to pass through.
Example
# Enable 20% broadcast cast to pass, i.e. 80% broadcast storm suppression is made
on broadcast traffic of port.
[Quidway-Ethernet0/1] broadcast-suppression 20
1.1.2 description
Syntax
description text
undo description
View
Ethernet port view

Huawei Quidway S2000 Series Specifications

General

Brand	Huawei
Model	Quidway S2000 Series
Category	Switch
Language	English