To Next Page

To Previous Page

Command Manual - System Management

Quidway S2000 Series Ethernet Switches Chapter 4 System Maintenance Commands

4-28

Description

Using info-center loghost source command, you can set source address of the

packets sent to loghost as the address of the interface specified by the interface-name.

Using undo info-center loghost source command, you can cancel the setting source

address of the packets sent to loghost.

This command takes effect only after the system logging is enabled.

For the related commands, see info-center enable, display info-center.

Example

# Set source address of the packets sent to loghost as the address of the VLAN

interface 1.

[Quidway] info-center loghost source vlan-interface 1

4.5.9 info-center monitor channel

Syntax

info-center monitor channel { channel-number | channel-name }

undo info-center monitor channel

View

System view

Parameter

channel-number: Channel number, ranging from 0 to 9, that is, the system has ten

channels.

channel-name: Specify the channel name. The name can be channel6, channel7,

channel8, channel9, console, logbuffer, loghost, monitor, snmpagent,

trapbuffer.

Description

Using info-center monitor channel command, you can configure the channel to

output the log information to the user terminal. Using undo info-center monitor

channel command, you can restore the channel to output the log information to the

user terminal to default value.

By default, Ethernet switches do not output log information to user terminal.

Huawei Quidway S2000 Series User Manual

Questions and Answers: