Command Manual - Security
Quidway S2000 Series Ethernet Switches Chapter 2 AAA Configuration Commands
2-9
Parameter
disable: means disabling the user to use idle-cut function .
enable: means enabling the user to use idle-cut function.
minute: Specifies the maximum idle time, ranging from 1 to 120 and measured in
minutes.
flow: The minimum data traffic, ranging from 1 to 10,240,000 and measured in bytes.
Description
Using idle-cut command, you can configure the user template in the current ISP
domain.
By default, after an ISP domain is created, this attribute in user template is disable, that
is, the user idle-cut is disabled.
The user template is a set of default user attributes. If a user requesting for the network
service does not have some required attributes, the corresponding attributes in the
template will be endeavored to him as default ones. The user template of the switch
you are using may only provide user idle-cut settings. After a user is authenticated, if
the idle-cut is configured to enable or disable by neither the user nor the RADIUS
server, the user will adopt the idle-cut state in the template.
Because a user template only works in one ISP domain, it is necessary to configure
user template attributes for users from different ISP domain respectively.
For the related command, see domain
Example
# Enable the user in the current ISP domain, huawei163.net, to use the idle-cut
attribute specified in the user template (that is, enabling the user to use the idle-cut
function). The maximum idle time is 50 minutes and the minimum data traffic is 500
bytes.
[Quidway-isp-huawei163.net] idle-cut enable 50 500
2.1.9 local-user
Syntax
local-user user-name
undo local-user { user-name | all [ service-type { telnet | ftp | lan-access } ] }
View
System view
To Next Page
Loading...
Need help?
General