Huawei Quidway S2000 Series

Command Manual - Getting Started
Quidway S2000 Series Ethernet Switches Chapter 2 System IP Configuration Commands
2-3
Example
# Display all the host names and their IP addresses.
<Quidway> display ip host
Host Age Flags Address(es)
My 0 static 1.1.1.1
Aa 0 static 2.2.2.4
Table 2-2 Output description of display ip host command
Field Description
Host Host name
Age term of validity
Flags Flags
Address(es) IP address of the host
2.1.4 display ip interface vlan-interface
Syntax
display ip interface vlan-interface vlan-id
View
Any view
Parameter
vlan-id: Specifies the management VLAN interface ID.
Description
Using display ip interface vlan-interface command, you can view the information
about the management VLAN interface.
Example
# Display the information about the management VLAN interface 1.
<Quidway> display ip interface vlan-interface 1
Vlan-interface1 current state : DOWN ,
Line protocol current state : DOWN
Internet Address is 1.1.1.1/8 Primary
Broadcast address : 1.255.255.255
The Maximum Transmit Unit : 1500 bytes
input packets : 0, bytes : 0, multicasts : 0
output packets : 0, bytes : 0, multicasts : 0