Huawei Quidway S2000 Series User Manual

Command Manual - STP
Quidway S2000 Series Ethernet Switches Chapter 1 RSTP Configuration Commands
1-6
View
Ethernet port view
Parameter
enable: Sets the current Ethernet port as an edge port.
disable: Sets the current Ethernet port as a non-edge port.
Description
Using stp edged-port enable command, you can configure the current port as an
edge port. Using stp edged-port disable command, you can configure the current
port as a non-edge port. Using undo stp edged-port command, you can restore the
default setting.
By default, all the Ethernet ports of the bridge are configured as non-edge ports.
If the current Ethernet port is connected to other switch, you can use the stp
edged-port disable or undo stp edged-port command to specify it as a non-edge
port. The stp edged-port enable command can be used to configure the current
Ethernet port as an edge port. All the Ethernet ports have been set to non-edge ports
by initialization. You can configure the Ethernet ports directly connected to the user
terminals as edge ports, so that they can transition to forwarding state quickly.
For the related command, see stp point-to-point.
Example
# Set Ethernet 0/1 as a non-edge port.
[Quidway-Ethernet0/1] stp edged-port disable
1.1.7 stp loop-protection
Syntax
stp loop-protection
undo stp loop-protection
View
Ethernet port view
Parameter
none
Description
Using stp loop-protection command, you can enable loop protection function. Using
undo stp loop-protection command, you can restore the setting.

Huawei Quidway S2000 Series Specifications

General

Brand	Huawei
Model	Quidway S2000 Series
Category	Switch
Language	English