Command Manual - QoS/ACL
Quidway S2000 Series Ethernet Switches Chapter 3 Logon user’s ACL control command
3-3
Example
# Configures huawei as the community name, allows read-only access to the switch
by the name, meanwhile, performs the ACL control to the network management user
by ACL 2020. (Suppose ACL 2020 has been defined.)
[Quidway] snmp-agent community read huawei acl 2020
3.1.4 snmp-agent group
Syntax
snmp-agent group { v1 | v2c } group-name [ read-view read-view ] [ write-view
write-view ] [ notify-view notify-view ] [ acl acl-number ]
undo snmp-agent group { v1 | v2c } group-name
snmp-agent group v3 group-name [ authentication | privacy ] [ read-view
read-view ] [ write-view write-view ] [ notify-view notify-view ] [ acl acl-number ]
undo snmp-agent group v3 group-name [ authentication | privacy ]
View
System view
Parameter
v1: Configure to use V1 safe mode.
v2c: Configure to use V2c safe mode.
v3: Configure to use V3 safe mode.
groupname: Group name, ranging from 1 to 32 bytes.
read-view: Configures to allow read-only view settings.
readview: Read-only view name, ranging from 1 to 32 bytes.
write-view: Configure to allow read-write view settings.
writeview: Name of read-write view, ranging from 1 to 32 bytes.
notify-view: Configure to allow notify view settings.
notifyview: Specify the notify view name, ranging from 1 to 32 bytes.
acl acl-number: the number of basic ACL, ranging from 2000 to 2999
authentication: If this parameter is added to configuration command, the system will
authenticate but not encrypt SNMP data packets..
privacy: Configure to authenticate and encrypt the packet.
To Next Page
Loading...
Need help?
General