Huawei Quidway S2000 Series User Manual

Command Manual - System Management
Quidway S2000 Series Ethernet Switches Chapter 4 System Maintenance Commands
4-19
Example
# Check whether the host 202.38.160.244 is reachable.
<Quidway> ping 202.38.160.244
ping 202.38.160.244 : 56 data bytes
Reply from 202.38.160.244 : bytes=56 sequence=1 ttl=255 time = 1ms
Reply from 202.38.160.244 : bytes=56 sequence=2 ttl=255 time = 2ms
Reply from 202.38.160.244 : bytes=56 sequence=3 ttl=255 time = 1ms
Reply from 202.38.160.244 : bytes=56 sequence=4 ttl=255 time = 3ms
Reply from 202.38.160.244 : bytes=56 sequence=5 ttl=255 time = 2ms
--202.38.160.244 ping statistics--
5 packets transmitted
5 packets received
0% packet loss
round-trip min/avg/max = 1/2/3 ms
4.4.2 tracert
Syntax
tracert [ -a source-IP ] [ -f first-TTL ] [ -m max-TTL ] [ -p port ] [ -q nqueries ] [ -w
timeout ] string
View
Any view
Parameter
-a source-IP: Configure the source IP address used by tracert command.
-f: Configure to verify the -f switch, first-TTL specifies an initial TTL, ranging from 0 to
the maximum TTL.
-m: Configure to verify the -m switch, max-TTL specifies a maximum TTL larger than
the initial TTL.
-p: Configure to verify the -p switch, port is an integer host port number. Generally, user
need not modify this option.
-q: Configure to verify the -q switch, nqueries is an integer specifying the number of
query packets sent, larger than 0.
-w: Configure to verify the -wf switch, timeout is an integer specifying IP packet timeout
in seconds, larger than 0.

Huawei Quidway S2000 Series Specifications

General

Brand	Huawei
Model	Quidway S2000 Series
Category	Switch
Language	English