To Next Page

To Previous Page

Command Manual - System Management

Quidway S2000 Series Ethernet Switches Chapter 7 NTP Configuration Commands

7-11

The source address specifies where the packets are transmitted from.

You can use this command to designate an interface to transmit all the NTP packets

and take the source address of these packets from its IP address. If you do not want

any other interface to receive the acknowledgement packets, use this command to

specify one interface to send all the NTP packets.

Example

# Configure all the outgoing NTP packets to use the IP address of Vlan-Interface1 as

their source IP address.

[Quidway] ntp-service source-interface Vlan-Interface 1

7.1.13 ntp-service in-interface disable

Syntax

ntp-service in-interface disable

undo ntp-service in-interface disable

View

VLAN interface view

Parameter

None

Description

Using ntp-service in-interface disable command, you can disable an interface to

receive NTP message. Using undo ntp-service in-interface disable command, you

can enable an interface to receive NTP message.

By default, an interface is enabled to receive NTP message.

Example

# Disable Vlan-Interface1 to receive NTP message.

[Quidway] interface vlan-interface1

[Quidway-Vlan-Interface1] ntp-service in-interface disable

Huawei Quidway S2000 Series User Manual

Questions and Answers: