Command Manual - Port
Quidway S2000 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
1-18
1.1.24 reset counters interface
Syntax
reset counters interface [ interface_type | interface_type interface_num |
interface_name ]
View
User view
Parameter
interface_type: Specifies the port type.
interface_num: Specifies the port number.
interface_name: Specifies the port name in the interface_name= interface_type
interface_num format.
For parameter description, refer to the interface command.
Description
Using reset counters interface command, you can reset the statistical information on
the port. and count the related information again on the port for the user.
If the port type and number are not specified when clearing the port information,
information of all ports on the switch will be cleared. If only the port type is specified, all
the information on the ports of this type will be cleared. If both port type and port
number are specified, the information on the designated port will be cleared.
After 802.1X is enabled, the port information cannot be reset.
Example
# Reset statistical information on Ethernet port Ethernet0/1.
<Quidway> reset counters interface ethernet0/1
1.1.25 shutdown
Syntax
shutdown
undo shutdown
View
Ethernet port view
Parameter
none
To Next Page
Loading...
Need help?
General