Command Manual - Integrated Management
Quidway S2000 Series Ethernet Switches Chapter 1 HGMP V2 Configuration Commands
1-31
can cancel VLAN check for the communication inside a cluster on the administrator
device.
By default, VLAN check is performed.
Example
# Configure VLAN check for the communication inside a cluster.
[Huawei_0.Quidway-cluster] port-tagged vlan 1
1.3.17 reboot member
Syntax
reboot member { member-num | mac-address H-H-H } [ eraseflash ]
View
Cluster view
Parameter
member-num: Cluster member number.
H-H-H: MAC address of the member device to be reset.
eraseflash: Delete the configuration file when resetting the member device.
Description
Using reboot member command, you can reset a specified member device on the
administrator device.
The communication between the administrator device and member devices may be
interrupted due to some configuration errors, the member device can be controlled via
the remote control function of member device. For example, you can delete the booting
configuration file and reset the member device to restore the normal communication
between administrator device and member device.
When using the reboot member command, the user can decide to delete the
configuration file or not with the eraseflash parameter when the member device is
resetting.
Example
# Reset the cluster member 2.
To Next Page
Loading...
Need help?
General