Huawei Quidway S2000 Series

Command Manual - QoS/ACL
Quidway S2000 Series Ethernet Switches Chapter 3 Logon user’s ACL control command
3-4
Description
Using snmp-agent group command, you can configure a new SNMP group, and
perform the ACL control to the group through the parameter acl acl-number. Using
undo snmp-agent group command, you can cancel the SNMP group.
Example
# Creates a new SNMP group: huawei, and perform the ACL control to the group
through ACL 2021. (Suppose ACL 2021 has been defined.)
[Quidway] snmp-agent group v1 huawei acl 2021
3.1.5 snmp-agent usm-user
Syntax
snmp-agent usm-user { v1 | v2c } user-name group-name [ acl acl-number ]
undo snmp-agent usm-user { v1 | v2c } user-name group-name
snmp-agent usm-user v3 user-name group-name [ authentication-mode { md5 |
sha } auth-password ] [ privacy-mode des56 priv-password ] [ acl acl-number ]
undo snmp-agent usm-user v3 user-name group-name { local | engineid
engineid-string }
View
System view
Parameter
v1: Configure to use V1 safe mode.
v2c: Configure to use V2c safe mode.
v3: Configure to use V3 safe mode.
username: Specify the user name, ranging from 1 to 32 bytes.
groupname: Specify the group name corresponding to that user, a character string at
the length ranging from 1 to 32 bytes.
authentication-mode: Specify the safety level as authentication required.
md5: Specify the authentication protocol as HMAC-MD5-96.
sha: Specify the authentication protocol as HMAC-SHA-96.
authpassword: Specify the authentication password with a character string, ranging
from 1 to 64 bytes.
privacy-mode: Specify the safety level as encrypted.
des56: Specify the authentication protocol as DES.