Huawei Quidway S2000 Series

Command Manual - Network Protocol
Quidway S2000 Series Ethernet Switches Chapter 1 ARP Configuration Commands
1-3
1.1.3 debugging arp packet
Syntax
debugging arp packet
undo debugging arp packet
View
User view
Parameter
packet: ARP packet debugging.
Description
Using debugging arp command, you can enable ARP debugging. Using undo
debugging arp command, you can disable the corresponding ARP debugging.
By default, undo ARP debugging is enabled.
For the related command, see arp static, display arp.
Example
# Enable ARP packet debugging.
<Quidway> debugging arp packet
*0.771346-ARP-8-S1-arp_send:Send an ARP Packet, operation : 1,
sender_eth_addr :
00e0-fc00-3500,sender_ip_addr : 10.110.91.159, target_eth_addr :
0000-0000-0000
, target_ip_addr : 10.110.91.193
*0.771584-ARP-8-S1-arp_rcv:Receive an ARP Packet, operation : 2,
sender_eth_addr
: 0050-ba22-6fd7, sender_ip_addr : 10.110.91.193, target_eth_addr :
00e0-fc00-3
500, target_ip_addr : 10.110.91.159