Command Manual - Security
Quidway S2000 Series Ethernet Switches Chapter 2 AAA Configuration Commands
2-22
Parameter
ip-address
: IP address, in dotted decimal format. By default, the IP addresses of the
primary accounting servers is at 0.0.0.0.
port-number: Specifies UDP port number. ranging from 1 to 65535. By default, the UDP
port for accounting service is 1813.
Description
Using primary accounting command, you can configure the IP address and port
number for the primary accounting server. Using undo primary accounting command,
you can restore the default IP address and port number of the primary RADIUS
accounting server.
After creating a RADIUS server group, you are supposed to set IP addresses and UDP
port numbers for the RADIUS servers, including primary/second
authentication/authorization servers and accounting servers. In real networking
environments, the above parameters shall be set according to the specific
requirements. However, at least you have to set one authentication/authorization
server and an accounting server. Besides, ensure that the RADIUS service port
settings on the Ethernet switch is consistent with the port settings on the RADIUS
server.
For the related commands, see key, radius scheme, state.
Example
# Set the IP address of the primary accounting server of RADIUS server group,
“huawei”, to 10.110.1.2 and the UDP port 1813 to provide RADIUS accounting service.
[Quidway-radius-huawei] primary accounting 10.110.1.2 1813
2.2.9 primary authentication
Syntax
primary authentication ip-address
[
port-number ]
undo primary authentication
View
RADIUS server group view
Parameter
ip-address
: IP address, in dotted decimal format. By default, the IP addresses of the
primary authentication/authorization is at 0.0.0.0.
port-number
: Specifies UDP port number. ranging from 1 to 65535. By default, the UDP
port for authentication/authorization service is 1812 .
To Next Page
Loading...
Need help?
General