Command Manual - Security
Quidway S2000 Series Ethernet Switches Chapter 2 AAA Configuration Commands
2-4
In some occasions, it is necessary to disconnect a user or a category of users by force.
For the related command, see display connection.
Example
# Cut all the connections in the ISP domain, huawei163.net.
[Quidway] cut connection domain huawei163.net
2.1.4 display connection
Syntax
display connection [ access-type { dot1x | gcm } | domain domain-name | interface
interface-type interface-number | ip ip-address | mac mac-address | radius-scheme
radius-scheme-name | vlan vlanid | ucibindex ucib-index | user-name user-name ]
View
Any view
Parameter
access-type { dot1x | gcm }: Configures to display the supplicants according to their
logon type. dot1x means the 802.1x users. gcm means gcm user.
domain domain-name: Configures to display all the users in an ISP domain.
domain-name specifies the ISP domain name with a character string not exceeding 24
characters. The specified ISP domain shall have been created.
mac mac-address: Configures to display the supplicant whose MAC address is
mac-address. The argument mac-address is in the hexadecimal format (x-x-x).
radius-scheme radius-server-name: Configures to display the supplicant according to
RADIUS server name. radius-server-name specifies the RADIUS server name with a
character string not exceeding 32 characters, excluding “/”, “:”, “*”, “?”, “<” and “>”.
interface interface-type interface-number: Configures to display the supplicant
according the port.
ip ip-address: Configures to display the user specified with IP address. The argument
ip-address is in the hexadecimal format (ip-address).
vlan vlanid: Configures to display the user specified with VLAN ID. Here, vlanid ranges
from 1 to 4094.
ucibindex ucib-index: Configures to display the user specified with ucib-index.
user-name user-name : Configures to display a user specifies with user-name.
user-name is the argument specifying the username. It is a character string not
exceeding 32 characters, excluding “/”, “:”, “*”, “?”, “<” and “>”. The @ character can
only be used once in one username. The pure username (the part before @, namely
the user ID) cannot exceed 24 characters.
To Next Page
Loading...
Need help?
General