Command Manual - Security
Quidway S2000 Series Ethernet Switches Chapter 2 AAA Configuration Commands
2-31
Parameter
primary: Configures to set the state of the primary RADIUS server.
secondary: Configures to set the state of the second RADIUS server.
accounting: Configures to set the state of RADIUS accounting server.
authentication: Configures to set the state of RADIUS authentication/authorization.
block: Configures the RADIUS server to be in the state of block.
active: Configures the RADIUS server to be active, namely the normal operation state.
Description
Using state command, you can configure the state of RADIUS server.
By default, all the RADIUS servers in every RADIUS server group are in the state of
active.
For the primary and second servers (no matter an authentication/authorization or an
accounting server), if the primary server is disconnected to NAS for some fault, NAS
will automatically turn to exchange packets with the second server. However, after the
primary one recovers, NAS will not resume the communication with it at once, instead,
it continues communicating with the second one. When the second one fails to
communicate, NAS will turn to the primary one again. This command is used to set the
primary server to be active manually, in order that NAS can communicate with it right
after the troubleshooting.
When the primary and second servers are all active or block, NAS will send the
packets to the primary server only.
For the related commands, see radius scheme, primary authentication, secondary
authentication, primary accounting, secondary accounting.
Example
# Set the second authentication server of RADIUS server group, “huawei”, to be active.
[Quidway-radius-huawei] state secondary authentication active
2.2.19 stop-accounting-buffer enable
Syntax
stop-accounting-buffer enable
undo stop-accounting-buffer enable
View
RADIUS server group view
To Next Page
Loading...
Need help?
General