Huawei Quidway S2000 Series User Manual

Command Manual - Port
Quidway S2000 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
1-17
Parameter
vlan_id: VLAN ID defined in IEEE802.1Q, ranging from1 to 4094 and the default
vlan_id is 1.
Description
Using port trunk pvid vlan command, you can configure the default VLAN ID of trunk
port. Using undo port trunk pvid command, you can restore the default VLAN ID of
the port.
Trunk port and isolate-user-vlan cannot be configured simultaneously.
The default VLAN ID of local trunk port should be consistent with that of the peer one,
otherwise, the packet cannot be properly transmitted.
For the related command, see port link-type.
Example
# Configure the default VLAN of the trunk port Ethernet0/1 to 100.
[Quidway-Ethernet0/1] port trunk pvid vlan 100
1.1.23 port vlan filter disable
Syntax
port vlan filter disable
undo port vlan filter disable
View
Ethernet port view
Parameter
none
Description
Using port vlan filter disable command, you can disable the VLAN filtering function
of port. Using undo port vlan filter disable command, you can restore the VLAN
filtering function of the port.
By default, VLAN filtering function is enabled.
Example
# Disable the VLAN filtering function of Ethernet0/1.
[Quidway-Ethernet0/1] port vlan filter disable

Huawei Quidway S2000 Series Specifications

General

Brand	Huawei
Model	Quidway S2000 Series
Category	Switch
Language	English