To Next Page

To Previous Page

Command Manual - System Management

Quidway S2000 Series Ethernet Switches Chapter 4 System Maintenance Commands

4-15

[Subslot 0] 24 FE Hardware Version is REV.0

4.3 System Debug Commands

4.3.1 debugging

Syntax

debugging { all | module-name [ debugging-option ] }

undo debugging { all | module-name [ debugging-option ] }

View

User view

Parameter

all: Enable or disable all the debugging.

module-name: Specify the module name.

debugging-option: Debugging option.

Description

Using debugging command, you can enable the system debugging. Using undo

debugging command, you can disable the system debugging.

By default, all the debugging processes are disabled.

Ethernet Switch provides various kinds of debugging functions for technical support

personnel and experienced maintenance staff to troubleshoot the network.

Enabling the debugging will generate a large amount of debugging information and

decrease the system efficiency. Specially, network system may collapse after all the

debugging is enabled by debugging all command. So it is not suggested to use the

debugging all command. It is convenient for the user to disable all the debugging with

undo debugging all command.

For the related commands, see display debugging.

Example

# Enable IP Packet debugging.

<Quidway> debugging ip packet

Huawei Quidway S2000 Series User Manual

Questions and Answers: