Huawei Quidway S2000 Series

Command Manual - VLAN
Quidway S2000 Series Ethernet Switches Chapter 2 Isolate-User-Vlan Configuration Commands
2-2
Vlan Type: static
Private-vlan Type : Secondary
Route Interface: not configured
Description: VLAN 0004
Tagged Ports: none
Untagged Ports:
Ethernet0/4 Ethernet0/8
Vlan ID: 5
Vlan Type: static
Private-vlan Type : Secondary
Route Interface: not configured
Description: VLAN 0005
Tagged Ports: none
Untagged Ports:
Ethernet0/4 Ethernet0/18
2.1.2 isolate-user-vlan
Syntax
isolate-user-vlan isolate-user-vlan_num secondary secondary_vlan_numlist [ to
secondary_vlan_numlist ]
undo isolate-user-vlan isolate-user-vlan_num [ secondary secondary_vlan_numlist
[ to secondary_vlan_numlist
]
View
System view
Parameter
isolate-user-vlan_num
: VLAN ID of isolate-user-vlan, ranging from 1 to 4094.
secondary_vlan_numlist
: VLAN ID of Secondary vlan, ranging from 1 to 4094.
Description
Using isolate-user-vlan command, you can associate isolate-user-vlan to Secondary
VLAN and establish the mapping relationship between isolate-user-vlan and
Secondary VLAN. Using undo isolate-user-vlan command, you can cancel the
mapping relationship between isolate-user-vlan and Secondary VLAN.
By default, there is no any corresponding relationship between isolate-user-vlan and
Secondary VLAN created by the user.
Before the command is run, isolate-user-vlan and Secondary VLAN must include ports.
After the command is run, the mapping relationship between isolate-user-vlan and