Command Manual - Security
Quidway S2000 Series Ethernet Switches Chapter 1 802.1x Configuration Commands
1-5
and applies for dynamic IP addresses. Using undo dot1x dhcp-launch command, you
can disable DHCP to launch ID authentication on the supplicant.
By default, DHCP is not allowed launching user ID authentication.
Note that if the supplicant is a Windows XP user, you should enable this command
before performing 802.1x authentication.
For the related command, see dot1x.
Example
# Enable to launch ID authentication for the supplicant when he runs DHCP and applies
for dynamic IP addresses.
[Quidway] dot1x dhcp-launch
1.1.5 dot1x max-user
Syntax
dot1x max-user user-number [ interface interface-list
]
undo dot1x max-user [ interface interface-list
]
View
System view
Ethernet port view
Parameter
user-number
: Specifies the limit to the amount of supplicants on the port, ranging from
1 to 64. S
By default, the maximum user number is 64.
interface interface-list
: Ethernet interface list including several Ethernet interfaces,
expressed in the format
interface-list
= {
interface-num
[ to
interface-num
] } & < 1-10 >.
interface-num specifies a single Ethernet interface in the format interface-num =
{
interface-type
interface-num
|
interface-name
}, where
interface-type
specifies the
interface type, interface-num specifies the interface number and interface-name
specifies the interface name. For the respective meanings and value ranges, read the
Parameter of the Port Command Manual section.
Description
Using dot1x max-user command, you can configure a limit to the amount of
supplicants on the specified interface of 802.1x. Using undo dot1x max-user
command, you can restore the default value.
This command is used for setting a limit to the amount of supplicants that 802.1x can
hold on the specified interface. This command has effect on the interface specified by
To Next Page
Loading...
Need help?
General