Huawei Quidway S2000 Series User Manual

Command Manual - Integrated Management
Quidway S2000 Series Ethernet Switches Chapter 1 HGMP V2 Configuration Commands
1-20
Note: If the cluster function is disabled, you cannot create a cluster on the device or add
it to a cluster.
Example
# Enable the cluster function of a switch.
[Quidway] cluster enable
1.3.7 cluster switch-to
Syntax
cluster switch-to
{ member-num | mac-address H-H-H | administrator }
View
User view
Parameter
member-num: Member number of member device, ranging from 1 to 256.
mac-address H-H-H: MAC address of a member device.
administrator: Redirect from a member device to the administrator device.
Description
Using
cluster switch-to
command, you can switch between administrator device and
member devices for convenient management.
A member device in a cluster can be managed through the administrator device. The
user can operate on an administrator device and switchover to a specified member
device for configuration management, or operate on a member device and switchover
to an administrator device.
Authentication is required when the user switch from the administrator device to a
member device. Upon passing the member device authentication, the switchover is
allowed. If the password of the member device is different from the administrator device,
the switchover will be rejected. The user level will be inherited from the administrator
device when switching to the member device from administrator device. For example,
the user view will remain as user view after switching from the administrator device to a
member device.

Huawei Quidway S2000 Series Specifications

General

Brand	Huawei
Model	Quidway S2000 Series
Category	Switch
Language	English