Command Manual - System Management
Quidway S2000 Series Ethernet Switches Chapter 4 System Maintenance Commands
4-25
View
System view
Parameter
none
Description
Using info-center enable command, you can enable the system log function. Using
undo info-center enable command, you can disable system log function.
By default, system log function is enabled.
Only after the system log function is enabled can the system output the log information
to the info-center loghost and console, etc.
For the related commands, see info-center loghost, info-center logbuffer,
info-center console channel, info-center monitor channel, display info-center.
Example
# Enable the system log function.
[Quidway] info-center enable
4.5.6 info-center logbuffer
Syntax
info-center logbuffer [ channel { channel-number | channel-name } ] [ size
buffersize ]
undo info-center logbuffer [ channel | size ]
View
System view
Parameter
channel: Configure the channel to output information to buffer.
channel-number: Channel number, ranging from 0 to 9, that is, system has ten
channels.
To Next Page
Loading...
Need help?
General