Command Manual - Integrated Management
Quidway S2000 Series Ethernet Switches Chapter 1 HGMP V2 Configuration Commands
1-29
1.3.14 ip-pool
Syntax
ip-pool administrator-ip-address { ip-mask | ip-mask-length }
undo ip-pool
View
Cluster view
Parameter
administrator-ip-address: IP address of the administrator device of the cluster.
ip-mask: Mask of the cluster IP address pool.
ip-mask-length: Mask length of the cluster IP address pool.
Description
Using ip-pool command, you can configure a private IP address range for a cluster on
the command-switch-to-be. Using undo ip-pool command, you can restore the default
IP address configuration of the cluster.
By default, no IP pool is configured.
Before setting up a cluster, the user should configure a private IP address pool for the
member devices of the cluster. When a candidate device is added, the administrator
device will dynamically assign a private IP address, which can be used for
communication inside the cluster. In this way, the user can use the administrator device
to manage and maintain the member devices.
The commands can only be executed on a switch of non-cluster member. The IP
address pool of an existing cluster cannot be modified.
Example
# Configure the IP address pool of a cluster.
[Quidway-cluster] ip-pool 10.200.0.1 20
1.3.15 logging-host
Syntax
logging-host ip-address
To Next Page
Loading...
Need help?
General