Huawei Quidway S2000 Series User Manual

Command Manual - System Management
Quidway S2000 Series Ethernet Switches Chapter 5 SNMP Configuration Commands
5-11
View
System view
Parameter
groupname: Group name, ranging from 1 to 32 bytes.
authentication: Configure to authenticate the packet without encryption.
privacy: Configure to authenticate and encrypt the packet.
read-view: Configures to allow read-only view settings.
readview: Read-only view name, ranging from 1 to 32 bytes.
write-view: Configure to allow read-write view settings.
writeview: Name of read-write view, ranging from 1 to 32 bytes.
notify-view: Configure to allow notify view settings.
notifyview: Specify the notify view name, ranging from 1 to 32 bytes.
acl acl-list:Set access control list for this group name.
Description
Using snmp-agent group command, you can configure a new SNMP group, that is, to
map SNMP user to SNMP view. Using undo snmp-agent group command, you can
cancel a specified SNMP group.
For the following reasons:
z
snmp-agent target-host command automatically generates a notifyview for user
and adds it to the corresponding group.
z
Any change of the SNMP group notify view will affect all the users related to this
group.
Please do not specify the notify view when configuring SNMP group.
Example
# Create an SNMP group named huawei.
[Quidway] snmp-agent group v3 huawei.

Huawei Quidway S2000 Series Specifications

General

Brand	Huawei
Model	Quidway S2000 Series
Category	Switch
Language	English