Huawei Quidway S2000 Series User Manual

Command Manual - System Management
Quidway S2000 Series Ethernet Switches Chapter 7 NTP Configuration Commands
7-14
interface-number: Specify the interface number and determine an interface together
with the interface-type parameter.
priority: Designate a server as the first choice.
Description
Using ntp-service unicast-server command, you can configure NTP server mode.
Using undo ntp-service unicast-server command, you can disable NTP server
mode.
By default, version number number defaults to 3, the authentication is disabled, and the
local server is not the first choice.
The command announces to use the remote server at
ip-address
as the local time
server. ip-address specifies a host address other than an IP address of broadcast,
multicast, or reference clock. By operating in client mode, a local device can be
synchronized by a remote server, but not synchronize any remote server.
Example
# Designate the server at 128.108.22.44 to synchronize the local device and use NTP
version 3.
[Quidway] ntp-service unicast-server 128.108.22.44 version 3

Huawei Quidway S2000 Series Specifications

General

Brand	Huawei
Model	Quidway S2000 Series
Category	Switch
Language	English