Huawei Quidway S2000 Series

Command Manual - Port
Quidway S2000 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
1-3
Ethernet0/1 current state : UP
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 00e0-fc00-0010
Description : aaa
The Maximum Transmit Unit is 1500
Media type is twisted pair, loopback not set
Port hardware type is 100_BASE_TX
100Mbps-speed mode, full-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not supported
The Maximum Frame Length is 1522
Broadcast MAX-ratio: 100%
PVID: 1
Mdi type: auto
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
Last 5 minutes input: 0 packets/sec 0 bytes/sec
Last 5 minutes output: 0 packets/sec 0 bytes/sec
input(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts
input(normal): - packets, - bytes
- broadcasts, - multicasts
input: 0 input errors, 0 runts, 0 giants, - throttles, 0 CRC
0 frame, - overruns, 0 aborts, 0 ignored, - parity errors
Output(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output(normal): - packets, - bytes
- broadcasts, - multicasts, - pauses
Output: 0 output errors, 0 underruns, - buffer failures
- aborts, 0 deferred, 0 collisions, 0 late collisions
- lost carrier, - no carrier