Operation Manual - Getting Started
Quidway S6500 Series Ethernet Switches Chapter 2 Logging in Switch
Huawei Technologies Proprietary
2-2
Figure 2-3 Configuring the port for connection
Figure 2-4 Setting communication parameters
Step 3: The switch is powered on. Display self-test information of the Ethernet switch
and prompt you to press Enter to show the command line prompt such as <Quidway>.
Step 4: Input a command to configure the Ethernet switch or view the operation state.
Input a “?” for an immediate help. For details of specific commands, refer to the
following chapters.
2.2 Setting up Configuration Environment through Telnet
2.2.1 Connecting a PC to the Switch through Telnet
To connect a PC to the Switch through Telnet, you must configure to meet the following
requirements:
To Next Page
Loading...
