Operation Manual - QoS/ACL
Quidway S6500 Series Ethernet Switches Chapter 2 QoS Configuration
Huawei Technologies Proprietary
2-22
 Note:
A type card includes LS81FT48A, LS81FM24A, LS81FS24A, LS81GB8UA and
LS81GT8UA cards.
II. Configuration on the Cards except A Type Ones
Table 2-21 Setting traffic statistics
Operation Command
Set traffic statistics
traffic-statistic inbound { user-group { acl-number |
acl-name } [ rule rule ] | { ip-group { acl-number | acl-name }
[ rule rule ] | link-group { acl-number | acl-name } [ rule
rule ] }* }
Remove traffic
statistics setting
undo traffic-statistic inbound { user-group { acl-number |
acl-name } [ rule rule ] | { ip-group { acl-number | acl-name }
[ rule rule ] | link-group { acl-number | acl-name } [ rule
rule ] }* }
Display traffic
information
display qos-interface [ interface-name | interface-type
interface-num ] traffic-statistic
 Note:
Combined activating of IP ACL and Link ACL is supported by the cards except A type
ones. But the sum of the bytes number defined by IP ACL and that defined by the Link
ACL can not exceed 32 bytes; otherwise the ACL can not be activated.
2.2.12 Displaying and Debugging QoS Configuration
You can use the display command in any view to see the QoS operation after all these
configurations, further to check configuration result. You can also clear the statistic
information using the reset command in Ethernet port view.