Huawei Quidway S6500 Series User Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 7 NTP Configuration
Huawei Technologies Proprietary
7-11
Table 7-16 NTP display and debugging
Operation Command
Display the status of NTP service
display ntp-service status
Display the status of sessions maintained by
NTP service
display ntp-service sessions
[ verbose ]
Display the brief information about every NTP
time server on the way from the local
equipment to the reference clock source.
display ntp-service trace
Enable NTP debugging
debugging ntp-service
7.4 Typical NTP Configuration Example
I. Configure NTP server
1) Network requirements
On Quidway1, set local clock as the NTP master clock at stratum 2. On Quidway2,
configure Quidway1 as the time server in server mode and set the local equipment as in
client mode.
2) Networking diagram
......
Vlan-interface2:
1.0.1.11
Quidway0
Quidway1
Quidway2
Quidway3
Quidway4
Quidway5
Vlan-interface2:
1.0.1.12
Vlan-interface2:
3.0.1.31
Vlan-interface2:
3.0.1.32
Vlan-interface2:
3.0.1.33
1.0.1.2 3.0.1.2
Figure 7-2 Typical NTP configuration networking diagram
3) Configuration procedure
Configure Ethernet Switch Quidway1:
# Enter system view.
<Quidway1> system-view
# Set the local clock as the NTP master clock at stratum 2.
[Quidway1] ntp-service refclock-master 2
Configure Ethernet Switch Quidway2:

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English