Huawei Quidway S6500 Series User Manual

Operation Manual - QoS/ACL
Quidway S6500 Series Ethernet Switches Chapter 2 QoS Configuration
Huawei Technologies Proprietary
2-7
QoS
Features
LPUs excluding the
type A LPUs
Type A LPUs (LS81FT48A/
LS81FM24A/LS81FS24A/LS81GB8
UA/LS81GT8UA)
Traffic
counting
Count the packets
received by a port.
Count the packets received and sent
by a port.
The configuration tasks in system view include:
z Port mirroring
The configuration tasks in QoS view include:
z Packet filtering
z Traffic limit
z Line limit
z Traffic bandwidth
z Traffic redirection
z RED operation
z Priority relabeling
z Traffic statistics
You should first define an ACL first before initiating QoS configuration. Once you
activate an ACL, the packet filtering function is enabled. Therefore packet filtering
configuration will not be detailed here.
Only the rule with the action of permit can be activated by the QoS function
successfully.
2.2.1 Setting Port Priority
If the received packets contain no VLAN labels, the switch adds the default VLAN to
them and modifies their 802.1p priority levels with port priority levels.
Please perform the following configurations in Ethernet port view.
Table 2-2 Setting port priority
Operation Command
Set port priority
priority priority-level
Restore the default priority
undo priority
The switch supports eight priority levels, numbered as 0~7, according to your needs.
By default, the port priority level is 0.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English