EasyManuals Logo

Huawei Quidway S6500 Series User Manual

Huawei Quidway S6500 Series
647 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #410 background imageLoading...
Page #410 background image
Operation Manual - STP
Quidway S6500 Series Ethernet Switches Chapter 1 MSTP Region-configuration
Huawei Technologies Proprietary
1-18
You are recommended to use the stp root primary command to specify the network
diameter and Hello Time of the switching network, thus MSTP will automatically
calculate and give the rather desirable values.
By default, Forward Delay is 15 seconds, Hello Time is 2 seconds, and Max Age is 20
seconds.
1.2.9 Configure the Max Transmission Speed on a Port
The max transmission speed on a port specifies how many MSTP packets will be
transmitted every Hello Time via the port.
The max transmission speed on a port is limited by the physical state of the port and the
network structure. You can configure it according the network conditions.
You can configure the max transmission speed on a port in the following ways.
I. Configure in system view
Perform the following configuration in system view.
Table 1-11 Configure the max transmission speed on a port
Operation Command
Configure the max transmission speed
on a port.
stp interface interface-list
transmit-limit packetnum
Restore the max transmission speed on
a port.
undo stp interface interface-list
transmit-limit
II. Configure in Ethernet port view
Perform the following configuration in Ethernet port view.
Table 1-12 Configure the max transmission speed on a port
Operation Command
Configure the max transmission speed
on a port.
stp transmit-limit packetnum
Restore the max transmission speed on
a port.
undo stp transmit-limit
You can configure the max transmission speed on a port with either of the
above-mentioned measures. For more about the commands, refer to the Command
Manual.
This parameter only takes a relative value without units. If it is set too large, too many
packets will be transmitted during every Hello Time and too many network resourced
will be occupied. The default value is recommended.

Table of Contents

Other manuals for Huawei Quidway S6500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S6500 Series and is the answer not in the manual?

Huawei Quidway S6500 Series Specifications

General IconGeneral
BrandHuawei
ModelQuidway S6500 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals