Huawei Quidway S6500 Series User Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 3 Device management
Huawei Technologies Proprietary
3-10
Table 3-13 Configure queue traffic monitoring
Number Operation Command Remarks
1 Enter system view <Quidway> system-view
–
2
Enable queue
traffic monitoring
[Quidway] qe monitor
enable
Required. This
function is enabled by
default.
3
Set the overall
traffic threshold
[Quidway] qe monitor
overflow-threshold
threshold
Optional. Defaults to
50,000,000 bps.
To cancel the related configuration, use the qe monitor disable command.
3.6.2 Queue Traffic Monitoring Configuration Example
I. Network requirements
z Enable queue traffic monitoring.
z Set the overall traffic threshold used in queue traffic monitoring to 90 Mbps.
II. Configuration procedure
1) Enter system view.
<Quidway> system-view
[Quidway]
2) Enable queue traffic monitoring.
[Quidway] qe monitor enable
3) Set the overall traffic threshold used in queue traffic monitoring to 90 Mbps.
[Quidway] qe monitor overflow-threshold 90000000
3.7 Configuring Error Packets Monitoring
If the switch receives a great number of error packets, it will not be able to send/receive
packets properly. With error packets monitoring enabled, the switch collects information
about received error packets regularly. If error packets are detected, it takes protection
measures to ensure that its interfaces send/receive packets properly.
3.7.1 Error Packets Monitoring Configuration Task
The following describes configuration tasks of error packets monitoring.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English