Huawei Quidway S6500 Series User Manual

Operation Manual - Getting Started
Quidway S6500 Series Ethernet Switches Chapter 3 Command Line Interface
Huawei Technologies Proprietary
3-8
can invoke and execute them at any time later. History command buffer is defaulted as
10. That is, the command line interface can store 10 history commands for each user.
The operations are shown in the table below.
Table 3-3 Retrieve history command
Operation Key Result
Display history
command
display
history-command
Display history command by user
inputting
Retrieve the
previous history
command
Up cursor key <↑> or
<Ctrl+P>
Retrieve the previous history
command, if there is any.
Retrieve the next
history command
Down cursor key <↓>
or <Ctrl+N>
Retrieve the next history
command, if there is any.
 Note:
Cursor keys can be used to retrieve the history commands in Windows 3.X Terminal
and Telnet. However, in Windows 9X HyperTerminal, the cursor keys ↑ and ↓ do not
work, because Windows 9X HyperTerminal defines the two keys differently. In this
case, use the combination keys <Ctrl+P> and <Ctrl+N> instead for the same purpose.
3.3.4 Common Command Line Error Messages
All the input commands by users can be correctly executed, if they have passed the
grammar check. Otherwise, error messages will be reported to users. The common
error messages are listed in the following table.
Table 3-4 Common command line error messages
Error messages Causes
Cannot find the command.
Cannot find the keyword.
Wrong parameter type.
Unrecognized command
The value of the parameter exceeds the range.
Incomplete command The input command is incomplete.
Too many parameters Enter too many parameters.
Ambiguous command The parameters entered are not specific.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English