Huawei Quidway S6500 Series - Display the Current-Configuration and Saved-Configuration of Ethernet Switch; Save the Current-Configuration

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 1 File System Management
Huawei Technologies Proprietary
1-4
1.2.2 Display the Current-configuration and Saved-configuration of Ethernet
Switch
After being powered on, the system will read the configuration files from Flash for the
initialization of the device. (Such configuration files are called saved-configuration files).
If there is no configuration file in Flash, the system will begin the initialization with the
default parameters. Relative to the saved-configuration, the configuration in effect
during the operating process of the system is called current-configuration. You can use
the following commands to display the current-configuration and saved-configuration
information of the Ethernet switch.
Perform the following configuration in any view.
Table 1-5 Display the configurations of the Ethernet switch
Operation Command
Display the saved-configuration
information of the Ethernet switch
display saved-configuration
Display the current-configuration
information of the Ethernet switch
display current-configuration
[ controller | interface interface-type
[ interface-number ] | configuration
[ configuration ] | vlan [ vlan-id ] ] [ |
{ begin | exclude | include }
regular-expression ]
Display the running configuration of the
current view
display this
 Note:
The configuration files are displayed in their corresponding saving formats.
1.2.3 Save the Current-configuration
Use the save command to save the current-configuration in the Flash Memory, and the
configurations will become the saved-configuration when the system is powered on for
the next time.
Perform the following configuration in user view.
Table 1-6 Save the current-configuration
Operation` Command
Save the current-configuration save [ file-name | safely ]